* 본 페이지에는 대표 규격만 설정되어 있으니, 다양한 제품문의는 문의전화 또는 게시판을 이용해주세요.
Valve Outside
Size Table
Fitting Standard | Nonstandard | |
---|---|---|
Gate Size (mm) | 28mm x 222mm (1.1 x 8.7inch) | |
Pressure Range | 1.0xE-3 ~ 1.2xE5 Pa (abs) | |
Differential pressureon the gate | in closing direction | ≤ 0.12 Mpa |
in opening direction | ≤ 0.12 Mpa | |
Differential pressure at opening | ≤ 0.01 MPa | |
Helium leak rate | Housing | < 1.0xE-10 Pa*㎥/sec |
Seat (Gate) | PM: <1.3xE-5 Pa*㎥/sec (Hard Anodizing) | |
TM: <1.3xE-10 Pa*㎥/sec | ||
Open / Close Time | <2sec (Switch to switch) | |
Mounting Posture | Drive section is turnedto the top or bottom | |
Life Cycles | Mechanism | 3,000,000 cycles |
Bellows | 3,000,000 cycles | |
O-Ring (Seal) | 1,000,000 cycles | |
Lubrication | 1,000,000 cycles(under clean operating conditions) | |
Bake-out Temperature | Max. 120°C (Max. 60°C for air cylinders) | |
Pneumatic pressure(Compressed air pressure) | 0.5 Mpa (Tolerance Level : 0.45~0.6 Mpa) | |
Weight | <16 kgf | |
Material | Gate (Blade) | AL6061 |
Bellows | AM350 | |
Seal plate (Bonnet) | AL6061 | |
Actuator | AL6061, STS304, Etc | |
Shaft (Stem) | STS304 | |
Gate (Blade) seal | FKM (VITON®) | |
Pneumatic seal | FKM (VITON®) | |
Grease (Pneumatic) | PFPEGrease | |
Surface treatment | Gate (Blade) | (PM) Anodizing (TM) Anodizing |
Shaft (Stem) | Bare | |
Actuator | Anodizing | |
Speed controller connection tube diameter | 6ea Φ4Tube, Meter-out type° |
회사명 : 프리시스(주) 주소 : 경기도 수원시 권선구 서부로 1433-64 대표 : 서진천
사업자등록번호 : 124-81-65026 전화 : 031-8003-1133 팩스 : 031-8003-3399
copyright © 프리시스(주) All rights reserved.